OMAX 5555

OMAX 5555
The OMAX 5555 JetMachining® Center is a perfect fit for shops needing a machine with a smaller footprint but capable of cutting 4 foot x 4 foot. It is a cantilever-style machine, comes standard with the OMAX MAXJET® 5i Nozzle, and boasts a cutting tolerance of ±0.001” (±0.025 mm). With a completely sealed and protected Ball Screw Drive System, this robust and reliable workhorse is perfect for shops cutting projects needing high precision.
 
Table size of 6' 8" x 5' 5" (2,032 mm x 1,650 mm)
Rapid water level control for submerged cutting
A work envelope offering an X-Y cutting travel of 4' 7" x 4' 7" (1,397 mm x 1,397 mm)
 
Features:
 
-Fastest cutting speeds and best precision compared to any abrasivejet in the industry and is backed by our exclusive Intelli-MAX® Software with real world cutting data
-Programmable Motorized Z-Axis with a precision OMAX MAXJET®5i Nozzle can boost cutting productivity and process efficiency
-Tilt-A-Jet® taper compensating abrasivejet cutting head (available as an option)
-Precision X-Y Axis rigidly mounted to the cutting table
-Pre-loaded linear bearings and precision ball screws
-Low maintenance, high reliability scissor-style hard plumbing
-Drive system sealed against water, dirt, and grit
-Easy operator access to the work area
-High efficiency Generation 4 EnduroMAX® pump systems available in 30, 40, or 50 hp with operating efficiencies up to 85%
-Robust and accurate design for tight tolerance cutting and reliable operation
-Rapid Water Level Control for quiet and clean submerged cutting
-Bulk Abrasive Delivery System transports garnet from the assembly's large hopper into the Zero Downtime Hopper located on the Z-Axis
-Optional Variable Speed Solids Removal System (VS-SRS) designed for tough industrial use increases uptime through automated solids removal
-Shipped as a completely pre-assembled and factory-tested system
-Machines a wide range of materials and thicknesses, from metals and composites to glass and plastics
-Does not create heat-affected zones or mechanical stresses
-No tool changes and minimal fixturing reduces setup by 50% or more
-No additional water required for pump cooling
-Small, efficient footprint for minimal floorspace utilization
-Leaves behind a satin-smooth edge, reducing secondary operations
-No noxious gases, liquid or oils used in, or caused by, the machining process
-EnduroMAX pump technology delivers the highest nozzle horsepower in the industry for faster and more efficient cutting
-Completes most work below 80 dBA
-Environmentally "green" system with quiet and clean operation with low electrical consumption
-Highly robust and reliable pump design capable of over 1,000 hours between maintenance
Sort By:
Show:
Display: List Grid
  • OMAX 5555 JetMachining Center
    The OMAX 5555 JetMachining® Center is a perfect fit for shops needing a machine with a smaller footprint but capable of cutting 4 foot x 4 foot. It is a cantilever-style machine, comes standard with the OMAX MAXJET® 5i Nozzle, and boasts a cutting tolerance of ±0.003"(±0.08 mm). With a completely se..
    Request Quote